Glasscraft Entry Assembly Instructions - PDF download - Download Tools at the bottom of this page.

Please note that these instructions are for the assembly (prehanging) of your door unit prior to installation, and should not be confused with field installation instructions. It is recommended that instalation be performed by an experienced installer. All surfaces of the door, sidelite, transom, and/or millwork (inclusive of all edges and surfaces milled for hardware) should be sealed prior to assembly. If the unit has been ordered prefinished from GlassCraft, many of the steps outlined will not be necessary. Only the steps in bold type should be reviewed.

TOOL LIST
• Caulking gun & exterior caulk
• Hammer
• Screwgun
• Screwdriver
• Finish nailer & 2” nails (optional)
• Pin nailer & 1” nails (optional)
• Stapler & 3/8” staples (optional)

Parts Code (Note - Not all parts are in each entry. Code is marked on a label for each part.)
(H) Hinges
(T) T-Astragal(HJ) Hinge Jamb
(F) Flush Bolt(LJ) Leg Jamb
(SF) Sidelight Frame(HD) Header
(SS) Sidelight Sill (SW) Door Sweep
(GB) Glass Bead(W) Weatherstripping
(TF) Transom Frame(BM) Brickmoulding
(EM) Exterior Mull

Included with all door units are sufficient lengths of trim, including brickmould (bm) & interior casing (c). Units with sidelites and/or a transom also include lengths of exterior (em) and interior (im) mull . All trim is intentionally left long to allow for more flexibility in the field. It will be necessary to cut to length and/or mitre trim, as needed, before attaching to your assembled unit.

	Download Tools
ADOBE READER	WINZIP	STUFFIT EXPANDER